Web Access - NETGEAR GS748T Software Administration Manual

WARNING:
When you change the IP address of your administrative system,
you will loose your connection to the rest of the network. Be sure
to write down your current network address settings before you
change them.
To modify the network settings on your administrative system:
1. On your PC, access the MS Windows operating system TCP/IP Properties.
2. Set the IP address of the administrative system to an address in the 192.168.0.0 network,
such as 192.168.0.200. The IP address must be different from that of the switch but within
the same subnet.
3. Click OK.
To configure a static address on the switch:
1. Use a straight-through cable to connect the Ethernet port on the administrative system
directly to any port on the GS748T.
2. Open a Web browser on your PC and connect to the management interface as described in

Web Access

on page 16.
3. Change the network settings on the switch to match those of your network (this procedure is
described in IP Configuration
After you change the network settings on the switch, return the network configuration on your
administrative system to the original settings.
Web Access
To access the GS748T management interface, use one of the following methods:
• From the Smart Control Center, select the switch and click Web Browser Access.
• Open a Web browser and enter the IP address of the switch in the address field.
You must be able to ping the IP address of the GS748T management interface from your
administrative system for Web access to be available. If you used the Smart Control Center
to set up the IP address and subnet mask, either with or without a DHCP server, use that IP
address in the address field of your Web browser. If you did not change the IP address of the
switch from the default value, enter 192.168.0.239 into the address field.
GS748T Smart Switch
on page 33).
16