Firmware Upgrade - NETGEAR GS748T Software Administration Manual

To restore the configuration to a previously saved version:
1. Click the Maintenance tab and select the device with the configuration to restore.
2. Click Download Configuration.
3. From the Select a Configuration window that appears, navigate to and select the
configuration file to download to the switch.
4. Click Open.
Optionally, you can schedule a different date and time to download the configuration file.
To delay the download process, clear the Run Now? check box and enter a date and
time to complete the download.
5. Enter the switch password and click Apply to begin the download process.
Note: Click the Tasks tab to view status information about the
configuration download.

Firmware Upgrade

The application software for the GS748T Smart Switch is upgradable, enabling your switch to
take advantage of improvements and additional features as they become available. The
upgrade procedure and the required equipment are described in this section. This procedure
assumes that you have downloaded or otherwise obtained the firmware upgrade and that you
have it available as a binary file on your computer. This procedure uses the TFTP protocol to
implement the transfer from computer to switch.
Note: You can also upgrade the firmware using the TFTP Download and
HTTP Download features mentioned in this book. See
Upload on page 252.
To upgrade your firmware:
1. Click the Maintenance tab, and then click the Firmware link directly below the tabs (see
Figure 1 on page 12).
2. Select the switch to upgrade and click Download Firmware.
GS748T Smart Switch
20
HTTP File