Server Log Configuration - NETGEAR GS748T Software Administration Manual

Server Log Configuration

Use the Server Log Configuration page to allow the switch to send log messages to the
remote logging hosts configured on the system.
To access the Server Log Configuration page, click the Monitoring
the Server Log link.
To configure local log server settings:
1. Use the radio buttons in the Admin Status field to determine whether to send log
messages to the remote syslog hosts configured on the switch.
• Enable: Messages will be sent to all configured hosts (syslog collectors or relays)
using the values configured for each host.
• Disable: Stops logging to all syslog hosts. Disable means no messages will be sent to
any collector/relay.
2. In the Local UDP Port field, specify the port on the switch from which syslog messages are
sent.
3. Click Apply to save the settings.
The Server Log Configuration area also displays the following information:
• The Messages Relayed field shows the number of messages forwarded by the syslog
function to a syslog host. Messages forwarded to multiple hosts are counted once for
each host.
• The Messages Ignored field shows the number of messages that were ignored.
GS748T Smart Switch
243
Logs tab, and then click
