Factory Default - NETGEAR GS748T Software Administration Manual

To reboot the switch:
1. Select the check box on the page.
2. Click Apply to reset the switch immediately, or click Cancel to abandon the reset request.
After the switch reset begins, the management interface is not available until the switch
completes the boot cycle. After the switch resets, the login screen appears.

Factory Default

Use the Factory Default page to reset the system configuration to the factory default values.
Note: If you reset the switch to the default configuration, the IP address is
reset to 192.168.0.239, and the DHCP client is enabled. If you loose
network connectivity after you reset the switch to the factory
defaults, see
To access the Factory Defaults page, click Maintenance
To reset the switch to the factory default settings:
1. Select the check box on the page.
2. Click Apply, or click Cancel to abandon the changes. The switch resets immediately.
GS748T Smart Switch
Connecting the Switch to the Network
250
on page 11.
Reset Factory Default.
 