Step 5. Stopping The Diagnostics - IBM eServer pSeries 610 6C1 Installation Manual
Ibm eserver pseries 610 unix server installation guide
Hide thumbs
Also See for eServer pSeries 610 6C1:
- Technical overview and introduction (40 pages) ,
- Technical overview and introduction (42 pages) ,
- Service manual (377 pages)
Table of Contents
Advertisement
Step 5. Stopping the Diagnostics
To stop the diagnostics, do the following:
1. To exit the diagnostics, press the F3 key (from a defined terminal) or press 99 (from
an undefined terminal).
2. If you changed any attributes on your ASCII terminal to run the diagnostics, change
the settings back to normal.
3. This completes the system verification. If you received an error code, record the
code and report it to the service organization.
If the server passed all the diagnostic tests, the verification process is complete and
your server is ready to use.
Chapter 2. Verifying the Hardware Operation
31
Advertisement
Table of Contents
