Step 14. Connect The First External Scsi Device - IBM eServer pSeries 610 6C1 Installation Manual

Step 14. Connect the First External SCSI Device

If you have no external SCSI devices to attach, skip to "Step 17. Are You Using an
Ethernet Connection?" on page 21.
If you need to connect an external SCSI device, follow these steps. If you ordered the
optional SCSI converter cable and need it to connect an external SCSI device, begin
with step 1. If you do not need the converter cable, begin with step 3.
1. Connect the SCSI end of the converter cable (1) directly to the system unit.
2. Connect the other end of the SCSI converter cable to one end of the SCSI device
cable (2).
3. Connect the other end of the SCSI device cable (3) to the SCSI device.
4. Connect the SCSI device terminator (4) (if this is the last device to be connected).
The last device on a SCSI bus must be terminated.
Note: When a cable is not attached to the SCSI connector on the system unit, the
5. To set the SCSI device address, refer to the SCSI device documentation. For future
reference, you can record the address in Appendix D, "System Records" on
page 109.
18
Installation Guide
connector is automatically terminated (internally).
3
2
4
2
1