Step 5. Attach The Mounting Hardware To The Rack Enclosure - IBM eServer pSeries 610 6C1 Installation Manual
Ibm eserver pseries 610 unix server installation guide
Hide thumbs
Also See for eServer pSeries 610 6C1:
- Technical overview and introduction (40 pages) ,
- Technical overview and introduction (42 pages) ,
- Service manual (377 pages)
Table of Contents
Advertisement
Step 5. Attach the Mounting Hardware to the Rack Enclosure
1. Install the cage nuts for the rack rails and the cable management arm on the
mounting rails of the rack enclosure.
Note: You must align the rack rails correctly. Otherwise, the installation cannot be
a. Position the template on the front mounting rail, aligning the holes.
b. Install the cage nuts, using the locations shown on the template.
c. Move the template to the rear mounting rails.
d. Install the cage nuts, using the locations shown on the template.
completed successfully.
Front View
Rack
Mounting
Template
Rear View
Rack
Mounting
Template
Chapter 1. Setting Up the System
5
Advertisement
Table of Contents
