Step 3. Running System Verification; Step 4. Additional System Verification; Step 5. Stopping The Diagnostics - IBM H80 User Manual

v Return to substep 5 when you finish checking the attributes.
5. Turn on the power.
a. When the keyboard indicator displays, press the numeric 5 key on the keyboard
b. Enter requested passwords.
c. Follow any instructions to select a console.
6. When the Diagnostic Operating Instructions display, go to "Step 3. Running System
Verification". If you are unable to load the diagnostics, go to "Problem Determination
When Unable to Load Diagnostics" on page 124.

Step 3. Running System Verification

On the Diagnostic Operating Instructions screen, do the following:
1. Press Enter.
2. If the terminal type has not been defined, you must use the Initialize Terminal
option on the Function Selection menu to initialize the operating system
environment before you can continue with the diagnostics.
3. If you want to do a general checkout with minimal operator action, select the
Diagnostic Routines option on the Function Selection menu.
If you want to do a more complete checkout including the use of wrap plugs, select
the Advanced Diagnostics option on the Function Selection menu. The advanced
diagnostics are primarily for the service representative; they may instruct you to
install wrap plugs to better isolate a problem.
4. Select the System Verification option on the Diagnostic Mode Selection menu.
5. If you want to run a general checkout of all installed resources, select the All
Resource option on the Diagnostic Mode Selection menu.
If you want to check one particular resource, select that resource on the Diagnostic
Mode Selection menu.
6. Go to "Step 4. Additional System Verification".

Step 4. Additional System Verification

The checkout programs end with either the Testing Complete menu and a message
stating No trouble was found, or the A Problem Was Detected On (Time Stamp) menu
with a service request number (SRN).
1. Press Enter to return to the Diagnostic Mode Selection menu.
2. If you want to check other resources, select the resource. When you have checked
all of the resources you need to check, go to "Step 5. Stopping the Diagnostics".

Step 5. Stopping the Diagnostics

If you are running the Online diagnostics, use the following procedure to shut down the
system:
116
User's Guide
to load the Standalone Diagnostics or the numeric 6 key on the keyboard to
load the Online Diagnostics.