IBM eServer pSeries 610 6C1 Installation Manual page 108

Step 13
Did the Diagnostic Selection Menu display?
NO
YES
Step 14
The All Resources option checks most of the configured adapters and devices.
Select and run the diagnostic tests on the resources you are having problems with or
select the All Resources option to check all of the configured resources. Find the
response in the following table and follow the instructions given in the Action column.
Diagnostic Response
An SRN is displayed.
The system hangs.
The Testing Complete menu and the No
trouble was found message displays and you
have not tested all of the resources.
The Testing Complete menu and the No
trouble was found message displays and you
have tested all of the resources.
Step 15
The diagnostics produced an SRN for this problem. Do the following:
1. Record the SRN and other numbers read out.
2. Report the SRN to the service organization.
3. STOP. You have completed these procedures.
92
Installation Guide
If Problem Determination was selected from the Diagnostic Mode
Selection menu, and if a recent error has been logged in the error log,
the diagnostics automatically begin testing the resource. Follow the
displayed instructions.
v If the No Trouble Found screen is displayed, press Enter.
v If another resource is tested, repeat this step.
v If the Diagnostic Selection menu is displayed, go to "Step 14".
v If an SRN is displayed, record it, and go to "Step 15".
Go to "Step 14".
Action
Go to "Step 15".
Report SRN 109-200.
Press Enter and continue with the testing.
Go to "Step 18" on page 93.