Step 20. Connect the Power Cables to Electrical Outlets
Plug the power cables for the system unit, display, and attached devices into electrical
outlets.
When the power cables are plugged into the electrical outlets, the following occurs:
v The operator panel displays OK, and the green power LED (1) blinks. When this
occurs, your system is in standby mode. The following figure shows the operator
panel in standby mode.
1
1
2
If your system does not stop in standby mode, check all cables for good connection.
If you cannot find a problem, call your support center for assistance.
2
OK
Power-On LED
Operator Panel Display
Chapter 1. Setting Up the System
25