Removing Adapters
1. If you have not already done so, shut down the system as described in "Stopping
the System Unit" on page 34.
2. If you have not already done so, unplug the system unit power cables from the
electrical outlets.
3. If your server is a Model 6C1 (rack mount), place the server in the service position
as described in "Placing the Model 6C1 in the Service Position" on page 35.
4. If you have not already done so, remove the service access cover as described in
"Removing the Service Access Covers" on page 37.
5. Determine which adapter you are removing.
6. Disconnect any cables attached to the adapter.
7. If you are removing a long adapter, press on the touchpoint on the adapter retainer
flap (3) at the end of the slot nearest the front of the server, and rotate the adapter
retainer flap upward.
58
Installation Guide
4
3
1
Adapter retention latch
2
Tab
3
Adapter retainer flap
4
Adapter
2
1