Repair Action - IBM eServer pSeries 610 6C1 Installation Manual

Repair Action

1. Replace the failing component with the new component. Refer to Chapter 3,
"Installing Options in Your System" on page 33 for instructions.
2. Log in as root user.
3. At the command line, type diag.
4. Select Task Selection.
5. Select Log Repair Action.
6. Select the device that was repaired. (If the device is not listed, select sysplanar0)
7. Press F10 to exit diagnostics.
If the Attention LED remains on after you have completed the repair action and reset
the LEDs, call for service.
86
Installation Guide