IBM eServer pSeries 610 6C1 Installation Manual page 88

Note: You do not need to turn off the power to the server to install hot-swap power
1. If your system does not have a redundant (third) power supply installed, shut down
the system as described in "Stopping the System Unit" on page 34 and turn off the
power to the server and peripheral devices. Otherwise, go to the next step.
2. To remove the power supply (1):
a. Unplug the power cord connector from the power supply.
b. Remove the defective power supply by placing the handle (5) on the power
3. If you are not replacing the power supply:
a. Install a power-supply filler panel (2).
b. Open the cable-restraint bracket (3) and remove the power cord from the
c. Unplug the power cord from the electrical outlet.
If you are replacing the power supply:
a. Place the handle (5) on the power supply in the open position, and slide the
b. Gently close the handle on the power supply to seat the power supply in the
c. Plug the power cord for the power supply into the power cord connector (4).
d. Verify that the AC Power light (6) and DC Power light (7) are lit, indicating that
e. If you have other options to install, refer to "Option List" on page 36.
72
Installation Guide
supplies if your system has a redundant (third) power supply installed.
Attention: Be careful when you remove the hot-swap power supply; the power
supply might be too hot to handle comfortably.
supply in the open position (perpendicular to the power supply) and pulling the
power supply from the bay.
Note: During normal operation, each power-supply bay must have either a
power supply or filler panel installed for proper cooling.
cable-restraint bracket. Close the cable-restraint bracket.
power supply into the chassis.
bay.
the power supply is operating correctly.