Service Access Cover (Model 6C1) - IBM eServer pSeries 610 6C1 Installation Manual
Ibm eserver pseries 610 unix server installation guide
Hide thumbs
Also See for eServer pSeries 610 6C1:
- Technical overview and introduction (40 pages) ,
- Technical overview and introduction (42 pages) ,
- Service manual (377 pages)
Table of Contents
Advertisement
Service Access Cover (Model 6C1)
Refer to the following illustration to install the service access cover.
1. Align the service access cover (1) with the top of the server, about 25 mm (1 inch)
from the front of the server. The flanges on the left and right sides of the cover
should be on the outside of the server chassis.
2. Hold the cover against the server, and slide the cover toward the front of the server
until the cover clicks into place.
78
Installation Guide
3
1
Service access cover
2
Side latches
3
Flanges
1
2
Advertisement
Table of Contents
