IBM eServer pSeries 610 6C1 Installation Manual page 27

4. Secure the server in the rack enclosure.
a. Slide the server into the rack enclosure until the slide latches on the front
chassis brackets click into place.
b. Using a screwdriver, tighten the screws that hold the rear of the slide rails to the
rear of the rack.
c. Release the server and pull the server forward about halfway.
Note: To release the server, release the left and right slide latches and pull the
server forward.
d. Using a screwdriver, tighten the screws that hold the front of the slide rails to the
front of the rack.
e. Slide the server into the rack enclosure again until the slide latches on the front
chassis brackets click into place.
5. Optional: For additional security, such as might be needed when transporting the
rack, fasten the server to the rack enclosure by inserting a M6 by 16-mm screw
through the chassis bracket, mounting rail, and cage nut on each side.
Chapter 1. Setting Up the System
11