Replacing The Battery - IBM eServer pSeries 610 6C1 Installation Manual

Replacing the Battery

CAUTION:
A lithium battery can cause fire, explosion, or a severe burn. Do not recharge,
disassemble, heat above 100 degrees C (212 degrees F), solder directly to the
cell, incinerate, or expose cell contents to water. Keep away from children.
Replace only with the part number specified for your system. Use of another
battery may represent a risk of fire or explosion.
The battery connector is polarized; do not attempt to reverse the polarity.
Dispose of the battery according to local regulations.
1. If you have not already done so, shut down the system as described in "Stopping
the System Unit" on page 34.
2. If you have not already done so, unplug the system unit power cables from the
electrical outlets.
3. If your server is a Model 6C1 (rack mount), place the server in the service position
as described in "Placing the Model 6C1 in the Service Position" on page 35.
4. If you have not already done so, remove the service access cover as described in
"Removing the Service Access Covers" on page 37.
5. If you have not already done so, remove the processor and memory card cover as
described in "Removing and Replacing Processor and Memory Card Cover" on
page 41.
Chapter 3. Installing Options in Your System
79