Oki C310dn Maintenance Manual page 109

Oki Data CONFIDENTIAL
5.3.2.11 Self-diagnostic function setup
The self-diagnostic function setup is used for enabling or disabling the error detection by
sensors. The detection can be enabled or disabled temporarily for troubleshooting. Allowing
for setting engine operation options for which expert knowledge is required to be handled,
these self-diagnostic setup should be used carefully.
Be sure to restore the default settings of used options of the self-diagnostic function setup.
1. Enter the self-diagnostic mode and, until the following message appears, press
or .
SENSOR SETTING
2. Press or , and the following message appears. Press
to set (refer to the table shown below) appears.
TONER SENSOR
ENABLE
3. A setting can be selected on the lower display by pressing the OK button.
displays the next setting and
4. Hold down the OK button (for three seconds) with the display showing the
setting to set. The setting is stored in the EEPROM. The state for step 2 is
restored.
5. Repeat steps 2 through 4 when necessary.
6. Press to end setting the option (except where not in step 4) (the state for
step 1 is restored).
Display Settings
TONER ENABLE Performs detection. Enables or disables the toner
SENSOR
DISABLE Does not perform
detection.
BELT UNIT ENABLE Performs checking.
CHECK
DISABLE Does not perform
checking.
44346001TH Rev.1
or until an option
*
displays the preceding setting.
Behavior Function
sensor operation.
Enables or disables the belt
installation checking operation.
Display Settings Behavior
ID UNIT ENABLE Performs checking.
CHECK
DISABLE Does not perform
checking.
UP/DOWN ENABLE Performs detection. Enables or disables the image drum
SENSOR
DISABLE Does not perform
detection.
REG ADJUST ENABLE Has the printer to
pause.
ERROR
DISABLE Does not have the
printer to pause.
DRUM OVER STOP Does not extend
life.
LIFE
CONTINUANCE Extends life.
WR POINT 00H FFH A correction value.
REV
TBL=**H±
*.***mm
BOTTOM 00H FFH
A tear-off value.
WRT POINT
TBL=**H±
*.***mm
5. MAINTENANCE MENUS
Function
Enables or disables the image drum
installation checking operation.
up-down sensor operation.
Enables or disables the error display
based on a color misregistration
detection value.
Sets whether to enable or disable
extending image drum life at the
end of the life.
Adds a correction value for the
default writing point.
Sets a tear-off length from the
bottom edge of paper.
Default is in hatched area
109 /