System Keys - Agilent Technologies 66111A User Manual

System Keys

Refer to the examples later in this chapter for more details on the use of these keys.
This is the blue, unlabeled key, which is also shown as
Pressing this key accesses the alternate or shifted function of a key (such as
ERROR
indicating that the shifted keys are active.
Local
Press to change the dc source's selected interface from remote operation to local
(front panel) operation. Pressing the key will have no effect if the interface state
is already Local, Local-with-Lockout, or Remote-with-Lockout.
Address Press to access the address menu. All entries are stored in non-volatile memory.
Display
ADDRESS <value>
INTF <char>
BAUDRATE <char>
PARITY <char>
FLOW <char>
LANG <char>
REMOTE FP <char>
ROM <char>
SN: <char>
Recall
Press to place the dc source into a previously stored state. You can recall up to 4
previously stored states (0 through 3).
Shift Channel Pressing these keys toggles the display between output 1 and output 2.
Display
1
<reading>V <reading>A
2
<reading>V <reading>A
Shift
Error
Press to display the system error codes stored in the SCPI error queue. This
action also clears the queue. If there is no error in the queue, 0 is displayed.
Shift Save Press to store an existing dc source state in non-volatile memory. The
parameters saved are listed under *SAV as described in chapter 8. You can save
up to 4 states (0 through 3).
1
Notes: Not valid for Agilent 66309B/D
value = a numeric value
p
Use
È
Use
SYSTEM
Channel
Local
Figure 5-2. System Keys
). Release the key after you press it. The Shift annunciator is lit,
Command Function
Sets the GPIB Address
Selects an interface (GPIB or RS-232
Selects baudrate (300, 600, 1200, 2400, 4800, 9600)
Message parity (NONE | EVEN | ODD | MARK | SPACE)
Flow control (XON-XOFF | RTS-CTS | DTR-DSR | NONE)
Selects language (SCPI or COMP
Enable/disable Agilent14575A front panel interface (ON or
OFF)
Firmware revision number
Unit serial number
Measurement
Measures output channel 1
Measures output channel 2
char = a character string parameter
q
and to scroll through the command list.
É
and to scroll through the parameter list.
Front Panel Operation - 5
Error
Address
Save
Recall
Shift
1
)
1
)
in this guide.
1
1
1
51