Create Dmz Wan Inbound Service Rules - NETGEAR FVS318G Reference Manual

• WAN Users
Unless your selection from the Action list is BLOCK always, you also must make
selections from the following lists:
• Select Schedule
• QoS Priority
6. Click the Apply button.
Your changes are saved.

Create DMZ WAN Inbound Service Rules

The Inbound Services table lists all existing rules for inbound traffic. If you did not define any
rules, no rules are listed. By default, all inbound traffic (from the Internet to the DMZ) is
blocked.
Inbound rules that are configured on the LAN WAN Rules screen take precedence over
inbound rules that are configured on the DMZ WAN Rules screen. As a result, if an inbound
packet matches an inbound rule on the LAN WAN Rules screen, it is not matched against the
inbound rules on the DMZ WAN Rules screen.
IPv4 DMZ WAN Inbound Service Rules
To create an IPv4 DMZ WAN inbound rule:

1. Log in to the unit:
a. In the address field of any of the qualified web browsers, enter https://192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
b. In the Username field, enter admin and in the Password / Passcode field, enter
password.
Use lowercase letters. If you changed the password, enter your personalized
password. Leave the domain as it is (geardomain).
c. Click the Login button.
The Router Status screen displays. After five minutes of inactivity, which is the default
login time-out, you are automatically logged out.
2. Select Security > Firewall > DMZ WAN Rules.
The DMZ WAN Rules screen displays. The IPv4 radio button is selected by default. The
screen displays the IPv4 settings.
NETGEAR ProSAFE VPN Firewall FVS318G v2
Firewall Protection
150