NETGEAR FVS318G Reference Manual page 103

NETGEAR ProSAFE VPN Firewall FVS318G v2
Table 19. DMZ Setup screen settings for IPv6 (continued)
Setting Description
DHCPv6 for DMZ Connected Computers
DHCP Status Specify the status of the DHCPv6 server:
•
•
DHCP Mode
Domain Name
Server Preference Enter the DHCP server preference value. The possible values
Disable DHCPv6 Server. This is the default setting, and the DHCPv6 fields are
masked out.
Enable the DHCPv6 Server. If you enable the server, you must complete the
DHCPv6 fields.
Select a DHCPv6 mode:
• Stateless. The IPv6 clients generate their own IP address
by using a combination of locally available information and
router advertisements but receive DNS server information
from the DHCPv6 server. For stateless DHCPv6, you must
configure the RADVD and advertisement prefixes (see
Configure the IPv6 Router Advertisement Daemon and
Advertisement Prefixes for the DMZ
• Stateful. The IPv6 clients obtain an interface IP address,
configuration information such as DNS server information,
and other parameters from the DHCPv6 server. The IP
address is a dynamic address. (see
Pools
Enter the domain name of the DHCP server.
are 0–255, with 255 as the default setting.
This is an optional setting that specifies the server's preference
value in a server advertise message. The client selects the
server with the highest preference value as the preferred
server.
LAN Configuration
103
on page 104).
on page 106).
IPv6 DMZ Address