NETGEAR FVS318G Reference Manual page 359

b. In the Username field, enter admin and in the Password / Passcode field, enter
password.
Use lowercase letters. If you changed the password, enter your personalized
password. Leave the domain as it is (geardomain).
c. Click the Login button.
The Router Status screen displays. After five minutes of inactivity, which is the default
login time-out, you are automatically logged out.
2. Select VPN > IPSec VPN > VPN Policies.
The VPN Policy screen displays.
3. Next to the policy name for the Gateway 1–to–Gateway 2 autopolicy, click the Edit button.
The Edit VPN Policy screen displays.
4. In the General section of the screen, clear the Enable NetBIOS check box.
5. In the Traffic Selector section of the screen, make the following changes:
• From the Remote IP list, select Single.
• In the Start IP fields, type 10.0.0.2, which is the WAN IP address of Gateway 2.
6. Click the Apply button.
Your changes are saved.
Configure Gateway 2 at Site 2
To create a gateway-to-gateway VPN tunnel to Gateway 1, using the IPSec VPN wizard:

1. Log in to the unit:
a. In the address field of any of the qualified web browsers, enter https://192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
b. In the Username field, enter admin and in the Password / Passcode field, enter
password.
Use lowercase letters. If you changed the password, enter your personalized
password. Leave the domain as it is (geardomain).
c. Click the Login button.
The Router Status screen displays. After five minutes of inactivity, which is the default
login time-out, you are automatically logged out.
2. Select VPN > IPSec VPN > VPN Wizard.
The VPN Wizard screen displays.
3. Configure a gateway-to-gateway VPN tunnel using the following information:
• Connection name. Any name of your choice
• Pre-shared key. The same key as you configured on Gateway 1
• Remote WAN IP address. 10.0.0.1
NETGEAR ProSAFE VPN Firewall FVS318G v2
Monitor System Access and Performance
359