Fire; Ventilation Override Definitions - Trane IntelliPak I Programming, Troubleshooting Manual

FIRE

Supply Fan - Off
Inlet Vanes - Closed (if equipped)
Return Fan/Exhaust Damper - Off/Closed (if equipped)
Return Fan VFD - Min
OA Dampers - Closed
Heat - All heat stages Off (staged gas and elec.), Hydronic heat & Mod Gas Heat output
at 0%.
Occupied/Unoccupied output - De-energized
VO Relay - Energized (with VOM module installed)
VCM Preheater State - Off (with VCM installed)

Ventilation Override Definitions

Press ENTER to Review or Adjust
1. Pressing the NEXT key will bypass this section.
2. If the factory preset VOM modes (A, B, C, D, E) need to be
modified to meet specific application requirements, press the
ENTER key to advance to the following screens
Ventilation Override Definition
Supply Fan
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed.
Ventilation Override Definition
Supply Fan IGV/VFD
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed.
Ventilation Override Definition
Exhaust Fan/Dampers
1. Press the + or - key until the proper value is displayed.
2. Press the ENTER key to confirm this choice.
3. Press the NEXT key until the following screen is displayed.
RT-SVP04F-EN
Mode A
ON
Mode A
MIN
Mode A
ON/OPEN
System Programming SETUP
Used with: All Units when VOM is
installed
Used With: All Units when VOM is
installed
Factory Presets: Refer to
Definitions
Possible Values: On, OFF
Used With: All Units when IGV or
VFD is installed
Factory Presets: Refer to
Definitions
Possible Values: IN CONTROL,
MIN, or MAX
Used With: All Units when VOM and
Power Exhaust with Statitrac is
installed
Factory Presets: Refer to
Definitions
Possible Values: On/OPEN, OFF/
CLOSED
69