Setting Busy Tone Detection; Setting For A Pbx; Setting The Loop Current Detection Before Dialing - Kyocera FS-C8520MFP Service Manual

Item No.
U660

Setting busy tone detection

When a fax signal is sent, sets whether the line is disconnected immediately after a busy tone is
detected, or the busy tone is not detected and the line remains connected until T0 time-out time.
Fax transmission may fail due to incorrect busy tone detection. When set to 2, this problem may
be prevented. However, the line is not disconnected within the T0 time-out time even if the desti-
nation line is busy.
1. Select the setting.
On
Off
* : Initial setting: On
2. Press the start key. The setting is set.

Setting for a PBX

Selects the mode to connect an outside call when connected to a PBX.
According to the type of the PBX connected, select the mode to connect an outside call.
1. Select the setting.
Flash
Loop
* : Initial setting: Loop
2. Press the start key. The setting is set.

Setting the loop current detection before dialing

Sets if the loop current detection is performed before dialing.
1. Select the setting.
On
Off
* : Initial setting: On
2. Press the start key. The setting is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Display
Detects busy tone.
Does not detect busy tone.
Display
Flashing mode
Code number mode
Display
Performs loop current detection before dialing.
Does not perform loop current detection before dialing.
Description
Description
Description
Description
1-3-119
2MY/2MZ