Transfer/Separation Section; Detaching And Refitting The Intermediate Transfer Unit; Detaching And Refitting The Secondary Transfer Roller Unit - Kyocera FS-C8520MFP Service Manual

1-5-6 Transfer/separation section

(1) Detaching and refitting the intermediate transfer unit

Procedure
1. Open the right cover 1.
(See page 1-5-11)
2. Pull the intermediate transfer unit for-
wards by holding two knobs A(yellow)
3. .Change to the knob B from the knob A
and then remove the intermediate
transfer unit.
4. Check or replace the intermediate
transfer unit and refit all the removed
parts.
CAUTION: When refitting the transfer
roller unit, insert it in place until it clicks
in.

(2) Detaching and refitting the secondary transfer roller unit

Procedure
1. Open the right cover 1.
(See page 1-5-11)
2. Release two lock levers (yellow) and
then remove the secondary transfer
roller unit.
3. Check or replace the secondary trans-
fer roller unit and refit all the removed
parts.
ATTENTION:When refitting the second-
ary transfer roller unit, insert it in place
until it clicks in.
Intermediate
transfer unit
Lock lever (yellow)
Figure 1-5-30
1-5-17
r
Knobs B (yellow)
Figure 1-5-29
Lock lever (yellow)
Secondary
transfer roller unit
2MY/2MZ
Knobs A
(yellow)