Toshiba e-studio550 Service Manual page 82

5. 5. Disassembly and Replacement
[A] Control panel unit
(1) Open the front cover and take off the front side
right inner cover, toner cartridge drive unit and
toner recycle unit.
(2) Remove 2 screws and take off the control panel
bottom cover.
(3) Disconnect 3 connecters, remove 2 screws,
release harnesses from 2 clamps and take off
the control panel unit.
(4) Remove 10 screws, disconnect 2 connectors
and release the braket after disconnecting 1
connector at the counter.
(5) Disconnect 7 connectors, remove 6 screws and
take off the DSP board.
JUNE 2002 © TOSHIBA TEC
Control panel bottom cover
Connector
Connector
5 - 11 e-STUDIO550/650/810 CONTROL PANEL
Clamp
Connector
DSP board
Connector
Connector