Toshiba e-studio550 Service Manual page 321

(5) Remove 1 screw, disconnect 1 connector and
take off the large original exit sensor with the
bracket.
(6) Remove 1 screw and release the large
original exit sensor from the bracket.
(G-11) Read sensor
(1) Remove the ADF left cover.
(2) Remove 1 screw, disconnect 1 connector and
take off the read sensor with the bracket.
(3) Remove 1 screw and release the read sensor
from the bracket.
(G-12) Registration sensor/Original length sensor
(1) Remove the ADF left cover.
(2) Open the jam access cover, remove 5 screws
and take off the upper transport guide.
(3) Release each latch, disconnect each
connector, and take off the registration sensor
and original width sensors.
e-STUDIO550/650/810 RADF
Read sensor
Upper transport guide
Registration sensor
Original width sensor
16 - 84
Large original exit sensor
JUNE 2002 © TOSHIBA TEC