Toshiba e-studio550 Service Manual page 170

[D] Recovery blade
(1) Remove the recovery blade.
Notes: 1. The recovery blade is attached with a
double-faced tape, so remove the tape
compeletely before attaching a new blade.
2. Attach the recovery blade fitting its
bottom edge into the notch of the cleaner
frame.
[E] Cleaning brush
(1) Pull out the rear side holding shaft and take
off the cleaning brush.
[F] Drum separation finger
(1) Remove 2 screws and take off the plate at the
rear side.
e-STUDIO550/650/810 DRUM/CLEANER UNIT
Recovery blade
Cleaner flame
Drum surface
Cleaning brush
11 - 8
Recovery blade
A
Holding shaft
Plate
JUNE 2002 © TOSHIBA TEC