Toshiba e-studio550 Service Manual page 312

(4) Remove 3 clips and pull out the feed roller
shaft, pickup roller belt and pickup
intermediate shaft. Then take off the pickup
belt and feed roller.
(D-2) Separation roller
(1) Open the jam access cover.
(2) Remove the pickup unit.
(3) Remove 2 screws and take off the upper
guide unit.
(4) Remove 2 screws and take off the separation
unit.
(5) Remove the clip at the rear side, displace the
bushing and take off the separation roller from
the holder.
JUNE 2002 © TOSHIBA TEC
Pickup belt
Feed roller
Upper guide unit
Separation unit
Separation roller
16 - 75
Clip
Clip, Bushing
e-STUDIO550/650/810 RADF