Toshiba e-studio550 Service Manual page 201

[C] Brush
(1) Remove the transfer belt keeping/feeding section.
(2) Remove 1 screw and take off the plate spring.
(3) Move the transport guide to the rear side and
pull it out upward.
(4) Remove 1 clip and take off 3 gears.
Notes: 1. The gears a/c has a latch, and remove the
gears in the order a, b, c.
2. When installing each gear, make sure the
latch fits into the groove portion of the shaft.
(5) Remove 1 clip and take off the bushing.
(6) Push the brush to the rear side, take off
the front side shaft and pull out the brush upward.
Note: Do not touch the top of the brush with bare hands.
[D] Cleaning blade
(1) Remove the transfer belt keeping/feeding
section.
(2) Remove 3 screws and take off the cleaning
blade.
Notes: 1. When installing the cleaning blade, make
sure that both sides of the bosses are fit in
and screwed shut.
2. Do not touch the blade with bare hands
and make any scar on it.
3. Be careful not to mash the urethan seals at
both sides.
e-STUDIO550/650/810 TRANSFER/TRANSPORT UNIT
2
1
c
a
13 - 6
b
2
Clip
1
Bushing
Urethan seal
JUNE 2002 © TOSHIBA TEC