Toshiba e-studio550 Service Manual page 317

[G] Sensors/Switches
(G-1) Lifting tray upper limit sensor/Empty sensor/
Cover open/close sensor
(1) Open the jam access cover, remove 2 screws
and take off the upper guide cover.
(2) Disconnect the connectors and release the
latches and take off the lifting tray upper limit
sensor, empty sensor and cover open/close
sensor.
(G-2) Lifting tray lower limit sensor
(1) Remove the upper guide unit.
(2) Remove 2 screws and take off the upper
guide stay.
(3) Open the reverse guide, unjoint the front side
inlet and take off the guide toward the front
side.
(4) Remove 4 screws and take off the lower
guide.
(5) Disconnect 1 connector and take off the lifting
tray lower limit sensor.
e-STUDIO550/650/810 RADF
Cover open/close sensor
Empty sensor
Upper guide stay
Inlet
16 - 80
Lifting tray upper
limit sensor
Reverse guide
Lower guide
Lifting tray lower limit sensor
JUNE 2002 © TOSHIBA TEC