Toshiba e-studio550 Service Manual page 140

(6) Remove 1 clip, disconnect 1 connector, take
off 1 harness band and release the bypass feed
clutch.
(7) Remove 5 screws, disconnect 1 connector and
take off the stay.
(8) Disconnect 1 connector and remove 2 screws
to take off the solenoid.
Notes: 1. When installing the solenoid, install it for the
edge of the solenoid to get in phase with the
edges of the plate.
2. When installing the solenoid, fix it at the
position where the bosses of two gears are
put each other.
3. Put on the spring in the place shown by the
figure.
JUNE 2002 © TOSHIBA TEC
Connector
Spring
9 - 17 e-STUDIO550/650/810 PAPER FEEDING SYSTEM
Bypass feed clutch
Clip
Harness band
Bosses