Asynchronous Frequency; Menu Bar Position - Barco Galaxy NH-12 User Manual

A bullet shows the active setting
7.9.3.2

Asynchronous frequency

What can be done ?
The frequency can be set to either low or high. In the synchronous mode, the display will be refreshed at the same vertical frequency
as the displayed source.
In the asynchronous mode, the display will be refreshed at a fixed vertical frequency (50/100 Hz or 60/120 Hz) depending on the
OSD setting, instead of the vertical frequency of the displayed source.
Asynchronous frequency setting is only applicable in the Galaxy NW-7.
The low and high asynchronous frequency values are 50 Hz or 100 Hz.
The high asynchronous frequency values are 60 Hz or 120 Hz.
How to set the asynchronous frequency ?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Full-screen synchronous representation
5. Press → to open the menu
6. Use ↑ or ↓ to select Asynchronous frequency
7. Press → to open the menu
8. Use ↑ or ↓ to select Low or High
9. Press ENTER
Image 7-144
A bullet shows the active setting
7.9.4

Menu bar position

What can be done ?
The menu tool bar can be centered vertically , the range being from top of the screen to the middle of the screen. This can be useful
in applications where the top image content is not displayed (soft edge region).
How to center the menu ?
1. Press MENU to activate the tool bar
R59770122 BARCO GALAXY NH-12 04/05/2011
7. Advanced
131