7. Advanced
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Textbox
5. Press → to pull down the menu
6. Use ↓ or ↑ to enable (ON) or disable (OFF) the textbox
Image 7-134
7. Press ENTER
A white bullet shows the active setting
7.9.2
Stereo display settings
Overview
•
Introduction
•
Stereo Mode
It is not possible to show an interlaced source in stereoscopic mode.
7.9.2.1
Introduction
The Stereo display settings allow us to set what happens on the display side (output side) whereas the Input
stereo sync in the Image menu is done at the input of the projector
Mono Sources
When a mono source is connected to the projector, following settings can change the way it is displayed :
•
Full screen synchronous representation, see "Full screen synchronous representation", page 129
•
Stereo Mode, see "Stereo Mode ", page 128
Following illustrations give an overview on how (how = synchronous or asynchronous and which refresh rate) a mono source will be
displayed in function of its vertical refresh rate and for the different settings mentioned above. A mono source means that no stereo
sync is connected.
126
R59770122 BARCO GALAXY NH-12 04/05/2011