Remove in the professional stacker /stapler the punch waste
The dashboard of the control panel indicates if the punch waste tray is full. The print system
cannot punch when the punch waste tray is full. This instruction only describes the removal of
punch waste of the stacker/stapler. Refer to the user manual of the professional puncher how to
remove punch waste from the professional puncher.
[118] Location of the punch waste tray
IMPORTANT
Be careful when you perform maintenance tasks on optionals attached to the machine. When
you perform a maintenance task, such as replace a staple cartridge, remove waste, or solve
jams, other machine parts can continue with job process activities.
For more information, see:
Professional stacker / stapler on page 43
System monitoring on page 120
Procedure
Action
1
Open the front cover of the stacker/stapler.
2
Check that the guide (F-A2) is closed.
When the guide is open, you cannot pull out
the punch waste tray. If applicable, close the
guide.
3
Pull out the punch waste tray.
imagePRESS C800 Series
Remove in the professional stacker /stapler the punch waste
Chapter 7 - Maintain the print system
4
211