Table of Contents
Advertisement
Page 5-28
Cybex 900T Treadmill Service Manual
7.
Test the new display overlay.
A. Turn the main power switch in the front panel to the on (I) position.
B.
Plug the treadmill into the power outlet.
C.
Try each key to be sure that it functions properly.
Handrail Assembly
Tools Required
• Phillips head screwdriver
• ESD grounding strap
• Open end wrench
1. Turn the power off.
A. Turn the main power switch in the front panel to the off (0) position.
B.
Unplug the treadmill from the power outlet.
2.
Remove the console back cover.
A. Remove the eight Phillips head screws that hold the back cover to
the console.
NOTE: The display board is susceptible to damage from
a
discharge of static electricity.
While handling parts underneath the console cover use an ESD (Electro Static
Discharge) grounding strap. This eliminates the potential voltage (static)
difference between you and the equipment you are working on.
3.
Remove the handrail assembly.
A. While wearing an ESD strap, disconnect the top left connector and the lower
connector from the contact heart rate board. See Figure 19.
B. Using an open end wrench remove the four nuts that hold the handrail assembly to the
treadmill. See Figure 21.
Nuts -_......
=====::::::::::::::======~
/
/
~~
Figure 21
• •
• •
-:
• •
• •
• •
• •
• •
• •
• •
•
-:
• •
• •
• •
• •
• •
• •
• •
•
-:
• •
•
Advertisement
Table of Contents
