Table of Contents
Advertisement
3.6.4 Network Configuration
The IP address and other network settings are established via the Network Configuration screen. This is also where
you may optionally establish a hostname and enter the IP address of the location of any software updates.
For more information about installing software updates via TFTP, see
1.
From the main menu, scroll to Network Configuration and press Enter. A screen similar to the following is
displayed:
IP Address
·
Enter the IP address of the AVPP, defined by your system administrator.
Hostname (optional)
·
Change the default host name, if desired. This is the name of the AVPP to which you are connected, for identification
purposes only. You cannot enter any spaces in this field.
SVP-II TFTP Download Master
·
This entry indicates the source of software updates for the AVPP. Valid source locations are:
NONE - disables.
·
IP Address - the IP address of the network TFTP server that will be used to transfer software updates to the
·
AVPP.
DNS Server and DNS Domain
·
These settings are used to configure domain name services. Consult your system administrator for the correct
settings. These can also be set to DHCP. This will cause the DHCP client in the AVPP to attempt to automatically get
the correct setting from the DHCP server. The DHCP setting is only valid when the IP address is also acquired using
DHCP.
WINS servers
·
These settings are used for Windows Name Services. Consult your system administrator for the correct settings.
These can also be set to DHCP. This will cause the DHCP client in the AVPP to attempt to automatically get the
correct setting from the DHCP server. The DHCP setting is only valid when the IP address is also acquired using
DHCP.
When the name services are set up correctly, the AVPP can translate hostnames to IP addresses. Using Telnet, it
·
is also possible to access the AVPP using its hostname instead of the IP address.
Workgroup
·
As set in WINS.
Syslog Server
·
Logging can be set to Syslog or NONE. If Syslog is set, a message is sent to the Syslog server when an alarm is
triggered.
Disable Telnet service
·
Prevents Telnet access into the AVPP server. Reset the AVPP server for the change to take effect. Upon reset the
Telnet protocol server is not started.
The AVPP must be reset in order to set the configuration options. If the AVPP is in Maintenance Lock and you press Esc
, you will be prompted to reset the AVPP. At the reset prompt, press Y (Yes).
To manually reset AVPP, select Reset in the SVP-II Configuration screen and then press Y (Yes).
3600 Installation
IP Office
AVPP Installation and Configuration: AVPP Configuration Menu
Software Maintenance
15-601082 Issue 05b (23 September 2008)
.
66
Page 37
Advertisement
Table of Contents
