Avaya IP Office 3600 Series Installation Manual page 63

Hide thumbs Also See for IP Office 3600 Series:
Table of Contents

Advertisement

Doing a Site Survey Using a 3641 or 3645 Phone
1.
With the wireless phone powered off, simultaneously press and hold Power On/Start Call and Power Off/End
Call.
2.
After hearing two beeps, release Power On/Start Call, then release Power Off/End Call.
3.
If an admin password has been set, it must be entered to display the Admin menu. If no password is set, the Admin
menu is displayed.
4.
Scroll to and select Diagnostics.
5.
Select Run Site Survey.
6.
When the test is started, it is by default in "single SSID" mode. When the Any soft key is pressed (softkey A) all
access points regardless of SSID, are displayed and the softkey changes to say MyID. Pressing the MyID soft key will
revert the display to the "single SSID" mode and change the softkey back to Any.
7.
The display would look like the following for the multiple AP mode:
1 1 1 1 1 1
1 1 1 1 1 1
1 1 1 1 1 1
1 1 1 1 1 1
Any
1 1 1 1 1 1 – The last three octets of the on-air MAC address for a discovered access point.
·
2 2 – The signal strength from the access point.
·
3 3 – The channel number of the access point.
·
4 4 4 – The beacon interval configured on the access point.
·
Any/MyID – Softkey to toggle between "single SSID" and "any SSID" modes.
·
Detl/Smry – Softkey to toggle between the multiple access point (summary) display, and the
·
The following screen shows how the display would look when there are three access points configured with an SSID that
matches that of the Wireless IP Telephone. The first has a signal strength of –28dBm, is configured on channel 2, with a
beacon interval of 100ms. The second has a signal strength of –48dBm, is configured on channel 6, with a beacon
interval of 200ms. The third has a signal strength of –56dBm, is configured on channel 11 with a beacon interval of
100ms.
a b 7 b c 8
2 a e 5 7 8
2 a e 5 9 6
Any
When the Any SSID mode is selected, the summary display contains the first six characters of the access points SSID
instead of the beacon interval as in the example below.
a b 7 b
- 2 8
2 a e 5
- 4 8
2 a e 5
- 5 6
MyID
3600 Installation
IP Office
- 2 2
3 3
4 4 4
- 2 2
3 3
4 4 4
- 2 2
3 3
4 4 4
- 2 2
3 3
4 4 4
Detl
- 2 8
0 2
1 0 0
- 4 8
0 6
2 0 0
- 5 6
1 1
1 0 0
Detl
0 2
A L P H A
0 6
W S M T E S
1 1
v o i c e
Detl
Certifying the Installation: Site Survey
15-601082 Issue 05b (23 September 2008)
Page 63

Advertisement

Table of Contents
loading

Table of Contents