5. Certifying the Installation
5.1 Site Certification
The installer should not leave the site before performing installation verification.
These tests must be performed in typical operating conditions, especially if heavy loads occur. Testing sequence and
procedure is different for every installation. Generally, you should organize the test according to area and volume,
placing numerous calls to others who can listen while you perform coverage tests. Note any areas with excessive static or
clarity problems and report it to an Avaya engineer.
The coverage test will also require you to put the wireless phone in Site Survey mode and walk the entire coverage area
to verify all access points.
¨ Important
The installation is not complete until these certification steps have been performed. Do NOT hand out wireless
phones at a site that has not been certified.
3600 Installation
IP Office
15-601082 Issue 05b (23 September 2008)
Page 60