Testing A Wireless Phone - Avaya IP Office 3600 Series Installation Manual

4.5 Testing a Wireless Phone

Verify proper registration and operation of each wireless phone by performing the following tests on each wireless phone
in an active wireless area.
1. To power on the wireless phone, press Power On/Start Call. A series of messages are displayed as the wireless
phone acquires the system. The wireless phone should display the user extension. Any error messages should clear.
2. Press Power On/Start Call. The extension number should be replaced by information from the IP Office unit and
you should hear a dial tone. Place a call and listen to the audio quality. To end the call, press Power Off/End Call.
3. Place a call to the wireless phone and verify ring, answer, clear transmit and clear receive audio.
4. Press Power On/Start Call.
5. Press Power Off/End Call. Any line indicators should turn off and the extension number display will return.
6. Register any further phones.
7. If necessary the IP Office configuration can be altered as required for the user setup, for example user names and
button programming.
8. When completed, proceed to
3600 Installation
IP Office
Site Certification before handing over any phones to the users.
60
Phone Configuration: Phone Registration
15-601082 Issue 05b (23 September 2008)
Page 51