Table of Contents
Advertisement
4. Phone Configuration
4.1 Installation Requirements
This section covers registration of the 3600 Series phones following setup and configuration of the wireless network,
AVPP, TFTP server and if necessary DHCP server.
Pre-Installation Requirements
1.
¨ Battery Charge
Ensure that the battery pack on the wireless phone is fully charged.
2.
¨ TFTP Server
The TFTP server has been setup and tested.
3.
¨ Phone Software
The required 3600 series phone software has been placed onto the TFTP server.
¨ AVPP
4.
The AVPP has been configured.
5.
¨ Wireless Network
The wireless access points are operational and that a thorough site survey has been conducted.
6.
¨ DHCP Server (if being used)
The DHCP server, if being used, is running and has the necessary scopes configured to provide the same information
as listed for static IP address configuration listed below.
Tools Required
1.
¨ PC with IP Office Manager
Information Required
1.
¨ TFTP Server IP Address
2.
¨ AVPP IP Address
3.
¨ Wireless Network
The wireless access points are operational and that a thorough site survey has been conducted. Ensure that you have
the following information about the wireless network:
3.1.¨ SSID
3.2.¨ Frequency. For example 802.11a or 802.11b.
3.3.¨ Security information. For example WEP key and key length if that is the security method being used by the
wireless network.
4.
¨ Static IP Address Information
If not using a DHCP server, ensure that you have the following network information:
4.1.¨ IP Address for each phone.
4.2.¨ Sub-net mask
4.3.¨ Default gateway.
4.4.¨ Call Server IP (IP Office)
4.5.¨ Call Server Port (1719).
5.
¨ Phone User Details
For each phone, ensure you have the following information:
5.1.¨ Required extension number.
3600 Installation
IP Office
15-601082 Issue 05b (23 September 2008)
Page 46
Advertisement
Table of Contents
