Paper Alignment (Paper Buckle) At The Main Registration Roller - Toshiba FC-22 Manual

1. 6. 1 Paper alignment (paper buckle) at the main registration roller

If the paper feed roller has prematurely become defective, it is possible to extend its service life, if
necessary, by increasing the aligning amount, as a temporary measure until a replacement becomes
available.
<Operation procedure> (Use codes 439 to 452 in adjustment mode "05".)
Copier cassettes
1st
cassette cassette
Long size 439
Short size 440
(1)
Digital keys
0 5
POWER Paper
source code
SET
or
INTERRUPT
(Stored in memory)
(2) Check for any transfer void or "Z" fold. If a trans-
fer problem is present, try the values in de-
scending order as "31"→"30"→"29"··· until the
transfer void disappears. At the same time,
confirm that any paper jam has not occurred.
Also, when the aligning amount has been in-
creased, this may increase the scraping sound
which occurs when the paper scrapes on the
mylar sheet as it is transferred by the regis-
tration roller. If this scraping sound is irritat-
ing, try reducing the aligning amount.
(3) Do the same for ADU, LCF, bypass feeding,
thick paper 2 and thick paper 3.
Note:
When paper thinner than specified is used, paper jams may occur frequently at the registration section. In this
case, it is advisable to change (or reduce) the aligning amount.
However, if the aligning amount is reduced too much, this could cause the leading edge void to vary adversely.
So, when adjusting the aligning amount, try to choose the appropriate amount while checking the leading edge
void at the same time.
January 2000 © TOSHIBA TEC
2nd 3rd 4th
cassette cassette
441 443 445
442 444 446
(Current value displayed)
START
(Select a paper source)
1 - 53
ADU
Bypass
LCF
feeding
447
448 449 450
Digital keys
(Input a new value.)
START
ENERGY SAVER
(Test copy)
Transfer void
"Z" fold
Thick Thick
paper2 paper3
451 452
Power OFF/ON
FC-22 ADJUSTMENT