Bin-Shift Motor Rotation Abnormal - Toshiba FC-22 Manual

CC3 Bin-shift motor rotation abnormal
When the push switch SW2 or SW3 on the sorter controller board is pressed, does the bin unit
move upward (or downward)?
YES
Replace the lead-cam home position sensor (PI2).
NO
While the above procedure is proceeding, does the bin-shift motor rotate?
NO
Check if the lead-cam drive belt is properly fitted on the sprocket.
YES
Disconnect J15 on the sorter controller board. Does the resistance between J15-5 and J15-6
on the harness side measure approx. 3 Ω ?
NO
Check the wiring up to the bin-shift motor (M2). If it is normal, replace the bin-
shift motor (M2).
YES
Connect J15 on the sorter controller board. Having tester probes touch J15-5 (+) and J15-6
(–), press SW2; does the tester's pointer swing?
NO
Replace the sorter controller board.
YES
Replace the bin-shift motor (M2).
January 2000 © TOSHIBA TEC 4 - 41 FC-22 TROUBLESHOOTING