Self Diagnostic Mode - Toshiba FC-22 Manual

1. 2 Self Diagnostic Mode

Mode
Whole control panel light-
ing mode
Test mode
Test print mode
Adjustment mode
Setting mode
Note: Input method for various modes:
While pressing simultaneously the two digital keys corresponding to the mode you want to set
(for example, [0] and [5]), turn on the main switch [POWER].
<Operation procedure>
0 1
(All control-panel LEDs light)
Power
• Whole control-panel lighting mode (01) :
Notes: 1. During the "Check keys" mode, [CLEAR] alone can do.
During the "Whole control-panel lighting mode", [CLEAR] can clear the mode.
2. Check keys : Any key with LED (when it is pressed, the LED goes out.)
• Test mode (03)
• Test print mode (04)
• Adjustment mode (05) : Refer to Sec. 1.2.4 for adjustment modes.
• Setting mode (08)
FC-22 ADJUSTMENT
Input method
[0]+[1]+[POWER]
[0]+[3]+[POWER]
[0]+[4]+[POWER]
[0]+[5]+[POWER]
[0]+[8]+[POWER]
START
START
Any key without LED (When it is pressed, an indication is made in the message area.)
:Refer to Sec. 1.2.1 and 1.2.2 for test modes.
: Refer to Sec. 1.2.3 for test print modes.
: Refer to Sec. 1.2.5 for setting modes.
Meaning
All control-panel LEDs are lit,
and all LCD pixels are turned
on/off repeatedly.
Input/output signals are
checked
A test pattern print is made.
Adjustment of various items
Setting of various items
(Check Key)
1 - 6
Clearing
[C] or [POWER]
OFF/ON
[POWER] OFF/ON
[POWER] OFF/ON
[POWER] OFF/ON
[POWER] OFF/ON
CLEAR or POWER OFF/ON
(Exit)
CLEAR
(Exit)
January 2000 © TOSHIBA TEC