Toshiba FC-22 Manual page 137

[The original does not reach the aligning roller.]
Is the pick-up roller or feed roller stained?
YES
Clean the roller.
NO
Is the gap between the aligning plate and the feed roller too small?
YES
Adjust the gap.
NO
Is the transporting force of the pick-up roller or the feed roller insufficient?
YES
Replace the rollers.
[The original stops, skewed on the original glass.]
Is the aligning roller stained?
YES
Clean the roller.
NO
Is the transport belt stained?
YES
Clean the belt.
NO
Is the RADF correctly installed?
NO
Properly install the RADF in parallel to the copier.
Make sure that the skew and height are properly adjusted.
[The side edges of the original are out of alignment with the side edges of the copy.]
Is the slides set too wide in relation to the width of the original?
YES
Align the slides with the width of the original.
NO
Shift the original feeding tray back or forth to adjust.
January 2000 © TOSHIBA TEC 4 - 11 FC-22 TROUBLESHOOTING