Table of Contents
Advertisement
C38 Auto toner initializing error (K)
C39 Auto toner initializing error (C)
C3A Auto toner initializing error (M)
C3B Auto toner initializing error (Y)
Is the harness between the LGC board and the EPU drawer connector open-circuited?
Is any harness inside the EPU or the auto toner sensor harness open-circuited?
Is the auto toner sensor connector or the connector J119 on the LGC board disconnected?
YES
NO
1. Replace the auto toner sensor.
2. Replace the LGC board.
FC-22 TROUBLESHOOTING
Reconnect the connector. Replace the harness.
4 - 28
January 2000 © TOSHIBA TEC
Advertisement
Table of Contents
Troubleshooting
