4.1.6 Original jam in the RADF
E71 Original not reaching the aligning sensor
E72 Original not reaching the exit sensor
E73 Original not passing the exit sensor
E75 Second original not reaching the aligning sensor in 2-in-1 mode
E79 Prefeed jam
[Two or more originals are fed simultaneously.]
Have too many originals been placed?
YES
NO
Are the original sheets curled or folded too much?
YES
NO
Are different-size originals placed together?
YES
NO
Is the gap between the aligning plate and the feed roller too large?
YES
NO
Is the separation pad stained?
YES
Clean the separation pad.
FC-22 TROUBLESHOOTING
Reset the originals, following the specification.
Flatten and reset the originals.
Set only one-size originals.
Adjust the gap.
4 - 10
January 2000 © TOSHIBA TEC