Feed Motor Speed Adjustment - Toshiba FC-22 Manual

1.6.2 Feed motor speed adjustment

The paper transport speed of the registration roller vis-a-vis the image pirnt speed can be set to the
optimum value.
<Procedure>
(1) While pressing the digital keys [0] and [5] simultaneously, turn the power ON. (Adjustment mode)
(2) Set five sheets of A4-R (LT-R) paper into the bypass tray.
(3) Input [10] and press the [SETTINGS] key to perform the continuous printing of five "adjustment
charts" from the bypass tray.
(4) Since the printed sheets of "adjustment charts" are slightly shrunk after being fused, it it required to
wait one or two minutes to cool them for precise adjustment. Then, set those five sheets again into
the bypass tray in the same print direction, with the chart face upward.
(5) Without changing the mode [05], enter [406] and press [START].
While the "adjustment chart" sheets are fed and transported, the pitches in the black belt zone are
read.
(6) The step (5) is to be repeated five times automatically.
The displayed set value does not change until the fourth printing round and at the finel fifth round, a
newly set value is displayed.
(7) When a newly set value for aligning is displayed at the fifth round, press the [INTERRUPT] key to
update the set value.
If ERROR is displayed at the second paper feeding, press the [CLEAR] key and return to the step
(2).
FC-22 ADJUSTMENT 1 - 54 January 2000 © TOSHIBA TEC