10. Recovery mode
When you turn ON the power after an error occurs, you'll see following display.
Firmware Version Up Mode
Recovery mode : target 4–6 failed.
> make a connection from PC
Connect with dial-up network (see procedure 3), and the display changes as follows.
Firmware Version Up Mode
Recovery mode : target 4–6 failed.
Established serial connection with PC.
> Press START key to install new
firmwares.
Further procedure is the same as normal sequence.
January 2000 © TOSHIBA TEC
Target: #3
5 - 9
FC-22 FIRMWARE UPDATING