Paper Feeding Jam; Paper Misfeed From The Bypass - Toshiba FC-22 Manual

4.1.2 Paper feeding jam

E11 Paper misfeed from the ADU
Is any paper remaining in the paper feed area inside the ADU unit?
YES
Remove the paper.
NO
Is the connector J103 on the LGC board disconnected?
Is the harness between the LGC board and the ADU drawer connector open-circuited?
YES
Reconnect the connector. Replace the harness.
NO
1. Replace the LGC board.
2. Replace the ADU unit.
E12

Paper misfeed from the bypass

Is any paper set in the bypass tray?
YES
Does the paper remain within the specified paper weight and stack height ?
NO NO
Adjust the paper weight and stack height to follow the specification.
Does the bypass paper sensor work? Does the actuator return normally?
1. Use the test mode to confirm that the bypass paper sensor is working nor-
YES
2. Reconnect the bypass paper sensor connector.
NO
Repair the actuator if it is displaced.
January 2000 © TOSHIBA TEC
YES
Is there any foreign matter such as scrap of paper in the paper
transport path from the bypass feed section up to the registration
rollers?
YES
NO
Check if the bypass pick-up roller, bypass feed roller or separa-
tion pad is not deteriorated. Replace them if necessary.
mally.
4 - 3
Eliminate the foreign matter.
FC-22 TROUBLESHOOTING