(3) Remove the paper guide (2 screws).
(4) Placing your finger tip on each side of the roller,
take out the roller along with the bearings up-
ward.
Note: After setting the lower heat roller in the ma-
chine, check to make sure that the pressure
levers are fitted in the bearing grooves (at
the front and rear).
12.3.7
Lower exit roller and paper exit switch
(1) Take out the fuser unit.
(2) Slide the exit roller unit to the front and then
take it out toward you (1f2).
1550/1560 FUSER
Paper guide
Lower heat roller
1
2
Exit roller unit
12 - 6
Bearing's groove
Pressure lever
Mar. 1998 © TOSHIBA